Same here still chilly at night
I bought 5 tons of the clean fire pacific last year and they were the best pellets I've burned yet. Hot fire, very low ash.
I've burned LGs before...
I have an older mini not the A and it is my primary heating source for the house ( except when the temps get below 10 degrees).
The damper has a set...
I had -9 this morning on the mountain tops in WMASS.
Furnace kicked on during the night to supplement the pellet stove.
My wife is only concerned about the heat comming from it.
Could care less about anything else.
Have you put a thermostat on the stove yet?
You can run it at a constant temperature and the stove which can burn high/low or on/off.
Snowy thanks for the schematic. I'll save it so when my control bd dies I'll put one together.
Thanks for all your hard work on this.
A few times a year for a couple of hours but if there is a bad storm it has been out for a few days ( ICE storm)
Alway have my back up generator for...
About 18 last night and I'm burning Cleanfires Pacific
70 degrees in the house. :cheese:
Some smoke until the fire gets going.
I would have to be outside and watch it to really notice.
HAPPY BIRTHDAY KROOSER
Join Jim it's the best thing you can do !
The one I got from ebay had a nipple on it but I had to buy a smaller one.
Since my stove has a 1/8" hole i had trouble finding something that small....
I bought one off of Ebay and it was scaled 0-.25
Since the Enviro was suppose to be 0.11 is was mid range. I found out also that the recommend range...
I'm not that bad yet. No snow on the ground but it was cold and damp that I starts the stove Saturday morning and haven't stopped yet.
Down to 50 at...
Here is a link to a video on you tube showing a leaf blower in action.
Was at a university research lab and they had been hired to develope presto type logs using hay.
Since ground up hay has no binder they were playing...
Just a note for all potential people who want to try the vac thru the OAK. Make sure on your pellt stove that the OAK is connected to the burn pot....
I use a light coating of PAM. Just spray on a light coat.
This is my first full winter with the mini and it has been a power house pellet stove.
It was my only source of heat for a 1400 sq ft house. Second...
I have an Enviro mini and I tried the Enviro setting of .11 on high and the burn pot would fill up with ash.
I have mine on .22WC now and does much...
I thought that was the reason for the forum. To share information.
Now I don't have a baby country but maybe someone else does that would really like...
5+ tons this year. Almost all heating done with the pellet stove.
if it burns I pour !
Shut the stove down most of the afternoon gave it a good cleaning but had to fire it back up early evening when it started getting cold again.
1 ton left and will need to get more before the end of this winter.
Typical would be about 400 Ws but this depend on the ignitor size and would only be on when first starting up the pellet stove.
Running they take...
I do the leaf blower once a month and it make such a huge difference with the flame.
I'm burning Ligs and there is a LOT of ash
The guage has to be perfectley level. It is made to be in the vertical position when zeroed and while doing the test.
Never had a problem with two different stoves.
I blow mine out once a month for a couple of minutes.
Really helps the air flow
Separate names with a comma.