You just need some balast. A nice piece of 6x6 in the front of that box will
keep that from happeinig again............
Sounds like you are familiar with copper welding ?
Done a bit of TIG myself but not copper so......what type
of shielding gas is required ?...
I'm think that if this were my stove and i didn't want to damage the finish
in an area that shows i might duplicate the problem in an area...
not a whole lot of snow in houston normally ?
i have one from the dirt biking days and it does make a big difference
have seen magnetic covers for vents
was sitting there reading posts with my green Kromer warming my dome when i found this post.
sorry for your loss..........
Here's a little info from a welding program from a while back........
Oxygen is a catalist and aids in the burning process
Not explosive without...
Thats why i'm sharing this info.........
Ordinarily this would not have occured without a sudden shock to the system.
IMO this is a defective...
Makes sense for a mower type situation where a sudden stop could occur.
Mine was a blower and no sudden stop occured ? Never was it used as a...
I hate to answer a question with a question but.........
What is this Blue & Green board all about ?
I'm guessing it is similar to standard drywall....
Just wanted to share this with you
Stihl has opted to use a new engineering trick which might save them a few penneys
They have machined...
I've wondered about this for some time now............
The rated front rack capacity of these machines vs the weight of the winch ?
I've read the posts.
You said that you left the door open for 2-4 minutes
closed it and a short bit later this happened.
I've had this bang on...
you might try a wax type spray furniture polish like lemon pledge.
I use it on my snow shovel and 4 wheeler blade and it eliminates
the snow from...
Warm again !
sept 17 thru oct 27 !
I just can't believe it took this long ?
He had more excuses than..............
Would gladly have purchased one...
so here we are.............
I talked to my stove shop last week and he said that Quad approved the new board.
Said it should be in in about...
so the stove company wanted a picture of the broken board.
Hadn't thrown it out yet so they have it now.........we'll see
what happens next ?
nope ..........no one has had to replace a board on a Quad ???
got to chime in on this one..........
Went from a basement install where the stove would often back up when liting, filling the basement
better keep an eye on that WD as i used it on a hand saw once in a damp environment
and it rusted !!! Shortly after my install i noticed moisture in...
am i the only one..............?
got 2 messages from the stove shop
first says that the board will be covered under warranty
second says something...
so I cleaned the stove this weekend. Went to dust off that fiber board and
Broke into multiple pieces when I dusted it with a wisk broom.
resistor spark plugs ?
If i remember right it was over toward Lansing area.
The info was from Craigs list i think but was found here on this site.
A search should...
While brousing this great site last year i ran across a contact for billboard tarps.
Now i've tried a number of the locally available tarps...
might try some fine steel wool and then polish ?
The reason i was thinking that being on a well might make a difference was due to the softener salt
being added in the water. Was just...
well.........yes that was for house plumbing.
Looks like 2 votes for Pex..........
i'll take a look
I'm on a well with a softener. Plumbing is ageing and needing some repairs.
Problem areas are currently galv. Wondering whats recommended...
Separate names with a comma.