Separate names with a comma.
I think it must. It was amazing how well it freed them to move with the handle.
Since installing storage my second year it is never a problem.
I hope it gets much faster, been here a long time but it is now like my old 14K dialup basically unusable, Bummer...
I have never had totally stuck turbulators but I did have sticky ones before I put storage in. I followed Econoburns recommendation and put a few...
Look up boot jack. Helps to take off difficult to remove boots.
Thanks I will check the place in Stevens Point.
I did some of it a few years back. I was lucky enough to find 2 boxes of fiberglass pipe...
Looking for a good source of fiberglass pipe insulation to cover some more pipe in the boiler room.
What thickness would you...
We have a program with our electric coop where the rate is 1/2 the normal rate. It puts you on load management with a second meter and a radio...
When I did mine to looked as though I had it all removed. Nozzle came out and there was a nice straight edge on both ends. Factory said it could...
Funny though here in Wisconsin it was the Politicians that started the war on public workers.
The 2010 attack on government workers in...
After spending spending the last 28 years being a Firefighter it gets a little frustrating visiting one of my favorite boards to read about how...
Mine has troubles at hot start if it sits a few minutes. Manual says to use primer bulb. It will still seem like a flooded saw, 30 plus pulls to...
A lot of variables here.
Heat loss of home.
The first year I had my Econoburn 200 I heated with out storage. My house...
If you do a search here and spend some time reading about Empyre you will have your answer. From what I have read I would RUN!!!!!!
My logstor to copper connections I used the compression fittings that are used with alum apex. Five years so far and no problems.
Last summer a dealer had P&M BL displayed at a flea market. I think the model was 2840, the small one. The price was $8995 for boiler alone.
Not sure but I can delete them from my smart phone with a app called tapatalk.
I have used my Econoburn 200 both with and without storage. I can tell you with storage is so much nicer I would recommend that be in your plans...
No hard data for you but I had a Foamer setup to do my lines and I bailed a week before. I just could not get past not having a water proof...
Check into Logstor from Urecon. It has a thicker outer case, cost the same or less than thermopex and has larger insided diameter of the pex.
How much oil do you go through? What kinds of oil do you use?
Pretty darn close for a Traditional OWB vs Gasifier with storage.
Woodmaster, I think you might have been thinking of the P&M gasifier. The BL is...
Hey whats up with the Pack AJ Hawk gone, you going to change your name?
Typical Ted Thompson, no value for Veteran players.
Timer shuts down with coals left from previous burn.
1. Rake charcoal over nozzle, Light from above with propane cane torch.
2 .Place crumpled...
Bummer, so much for dreaming of a 1500 for my next boiler...
Haven't talked to you for a while, Are you up and running with the Econoburn yet?
I would say the garn probably has a smaller over all foot print if you consider clearances, piping, tank, expansion tank.
One thing that has been...
It would be quite easy to get a good estimate of how long storage would last if you have a Heat loss calculation for your house. I would guess...
Ok I was confused, I thought you were using it for return temp protection to effect the Boiler output temp.
I am by no means saying what is best. I was just giving firebox sizes for a comparison. After using mine for 5 years I have several areas that it...
Sounds cool, can you post a drawing of how it its set up?