Easy test - Try 5 bags of a different pellet - Results may vary.
Wet rag + Ash + Rub
I don't even have a clean out tee on my install. I run a 1 inch hose through the exhaust of the stove to the 90 and vacuum it out.
Then sweep from...
Do you scrape daily? Do you clean under the burn pot? If your stove is cycling A LOT you may need to turn the feed rate down low, to make the calls...
The 2 bolts should allow you to remove the auger and motor. There is a bolt that ties the auger to the motor that you could remove first. There is...
Just for info...
My home was rated at required 58k BTU @ -60 per energy audit, my boiler is rated at 60k, and keeps up just fine.
I heat my whole...
Room blower comes on based on ESP temperature.
Stove in picture looks to be in a very finished area.
I heat my downstairs to 75-80 (stove room) to keep upstairs around 70.
Just how stove heating...
Unless your probe can only fit somewhere low, like where the cold comes in from an open door. That will cause your stove to cycle bad no matter what.
-38 outside and everything is dead.
Thanks to the P68 and feed rate 6 everything inside is still stirring.
FogTech is another well known anti-fog brand, the wipes are quite convenient.
You could also invest in a pair of goggles with a fan built in (100$...
That would put your EVL at 3.5 (Vertical) + 8 (Horizontal) + 5 (90 or...
I have a 1500 pure sine inverter to run my stove, it takes about 380 watts to ignite and 180 to run,
The idea behind using a car is, you have a...
Pellet stove = Convection heater, I wouldn't use the radiant heat as a buying / selling point. The P series does get HOT compared to a lot of pellet...
Haha got us beat today, we've been so lucky this winter. Only -20s right now.
Your igniter is meant to be used.
A hepa filter / bag filter / regular shop vac will filter out a certain % of debris. Socking your exhaust would ideally just lower your suction. The...
This is always debated. Do what you prefer.
The Harman stove is a convection heater, not a radiant heater.
In manual mode:
The stove will idle...
I haven't had the problem since I went through my stove, see my signature for my resolution.
Maybe if you don't have an OAK.
If you are running a OAK and run in manual mode, if your distribution blower is not running, you are idling pellets...
Not likely, I'd just use the pump while you are gone. Set it, test it, and forget it.
Awesome! Well done.
Bypass vacuum switch and test
Bypass hopper switch and test
Check power to equipment (auger / blower etc)
This guy might be able to help you out.
I use a 15 gallon Lowes shopvac with a bag filter and hepa filter.
My bag filter didn't get full but I changed it for the new year. Hepa looked...
IT COULD CLEAN ITSELF!
Read the manual, it's available on the website.
I do under the burn pot every cleaning, but once a year would probably be fine.
Turn off the stove...
HALLOWEEN ZOMBIE POSTING YEAH!!!
Separate names with a comma.