Cleaned air sensor , replaced low limit switch working much better
Any idea where this would be located and/or what it looks like
I am unfamiliar with the term POF switch.
Airflow sensor is clean
Jumpers are correct
Yes,Thermostat was supplied with the stove, actually has the austroflamm logo on it,has worked fine for the last couple of seasons
rika austroflamm integra insert hard wired to rika thermostat
Normally when up to room temp it throttles down to a very low level flame or shuts down...
austroflamm integra insert hard wired to a room thermostat
Starts up runs perfectly, when room is up to temp normally the fire will throttle back to...
The last few days my rika insert will not reignite. Since this is my first season i have been trying different pellets.Platinum Fires (i liked them)...
Any suggestions on what the temp range would be good
Ex when home 70-72
Rika integra ii insert
New to pellets this season . what is the most efficient way to run the stove. The rika has a programmable thermostat capable...
First season using the pellet insert , Rika insert with wall mount temp control capable of two hating times per day Question is
What is the best way...
All I can think of is that the wood was in a bag of pellets
No other place it could come from
Removed the cover on the auger and found a small piece of wood jammed in the auger
Used a pair of pliers to remove it and free the auger
I do have a meter my first thought is to do a complete vacuuming and cleaning of the entire unit
Then remove the cover from the auger and check for...
Mine is an insert , but it was installed into a two sided fireplace that the building inspector had me block off the other side
So what I did was to...
Will check the gearbox also when I get home
As soon as I get home
What exactly am I looking for ?
The bottom of the auger is exposed
I cannot move it at all by hand , but I do not know if this...
Stove starts to cycle but no pellets and auger is not turning.
I emptied the hopper , vacuumed what I can see of the auger which is only about...
Emptied the hopper vacuumed checked what I could see of the auger nothing stuck where I could see
Any suggestions on what else it could be
I came home today to find the stove not running and showing the error code 0
Which I thought was for out of fuel , which it wasn't
The burn pot was...
Thanks it is on 001 I will leave it that way
Thank you I will call the service dept
New to this I do not see a button to im
New member and new pellet user , after much research I purchased a Rika integra ii insert from Earth sense
I installed it . Couple of problems the...
Separate names with a comma.