Separate names with a comma.
you can use thermosteel good up to 2500 deg. buy at autozone or advance auto ect.
"necessity is the mother of invention"
got it . just needed a few taps with a hammer to drive it back. hopefully just a cleaning will help.doesn't look to bad.
again hoot :)
thank you hoot! can i remove the motor after i remove the two bolts on the auger plate?
p38 has developed auger squeal. i am looking for a step by step instruction on the removal of the auger.
thank you in advance for any help.
hi and welcome,
i have had an accentra insert for 7 years and no OAK. my home is pretty tight and it works fine.
you may not need it. but it...
aahh! adult beverages. similar to a stove, service may be important.you don't want to drag a cheap generator 50+ miles each direction
if it needs...
burning powerhouse myself. good heat and lots of ash .however, the ash is large/ fluffy and almost all stays in the ash pan.i'm burning in a...
here is the post
i had some crazy issues with an accentra insert(2006 vintage) about a year ago.can't remember what the issues were ,thought it was the board or...
had to have the weldment and burnpot replaced on my accentra insert because of the holes. sure enough the new pot doesn't have the holes.
statesman 2006 vintage
Rob from Denrich in quakertown delivered my pellets today. 2 tons powerhouse($195 ea) and 2 tons o'malleys.($205 ea) plus delivery and i think he...
yes all fans stop ,all lights go out except the power light. a few seconds later the lights and fans come back on. occurs approx. every 15 min....
all lights go out except power and all fans stop .5 seconds later everything comes on again .
Yuupp! time for a new one. $82 and change is reasonable.you could also use a thunderbolt cartridge heater form grainger
might cost half that.
@hitch you might get away with a auto battery charger/starter with (120V) input from your genny to a 12V output car battery to inverter to your stove
@ swalz, i went thru that with my accentra insert and trying to avoid this w/my p38.
you would think harman would be more proactive with this...
just called my service dept and informed them of my concerns. the tech said harman probably would not replace the burn pot if there aren't
possibly lower left ,hose should look like aquarium tube
is harman fessing up that the five hole burn pots are defective in design ?
i know they will replace them under warranty.i just had one replaced...
i 2nd the vacuum switch or hose
try blowing air thru the hose ,it could be blocked w/dirt
hopper size is almost irrelevant. if you burn 3 tons a season you still have to add 3 tons to your stove no matter what size the hopper is
stove was returned y-day. other than the long wait ,i am very pleased with the work my dealer did. they repainted the entire stove and replaced...
burn pot came in and test burn completed
stove is being returned next wed.
i would still like to know where harman is getting burn pots....china?
stove was picked up 4 months ago to replace cracked auger tube. i have been very patient, knowing repairs might be fill in work for slow times...
just picked up 20 bags at my local HD.
white bag with stove pictured on front.
they have a fresh cut wood smell
@rickwa i'm not sure if they will be replacing the burn pot .i know they should.what does the tube kit
@louseyweather all clear in the...
found a crack/gap/separation during cleaning. similar in appearance to pics here in previous posts. the crack /gap/separation has been getting...
thanks for the info rickwa. the stove goes in for a feeder tube replacement
in the spring.i will have them take care of it then.