4 blink status code for Harmon Accentra Insert
- Thread starter investor7952
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
GVA
Minister of Fire
crausch
New Member
I had just posted in your other thread related to your cleaning the stove and switching modes. If all you did was clean your stove, and you have not touched your temp sensor probe, try uplugging the stove for a minute or two and then plug it back in. This will reset your control board. Then see if you get the same error.
- Status
Similar threads
