So I just Installed a new Jotul 400 DV gas fire place, converted it to propane installed proflame stepper valve setup and it runs great untill about 2 hrs in it will go out and on come back on if use the remote to cycle it again. I have tried all the different mode on the remote and the same results. The stove is only running on the back up battery pack, so I tried changing the batteries, and running it on a genorator, no change.
Replaced the remote, turned down the pilot flame, no change.
A bit stumped, maybe replace the board at this point?
Replaced the remote, turned down the pilot flame, no change.
A bit stumped, maybe replace the board at this point?
