door gasket (which isn't on the door on this stove) was dropping out.
Per forum and Internet/videos I picked up new 1/2"gasket cleaned it up and put a small bead of Rutland Cement in.
Paper between door and gasket is tight, but manual and folks here say dollar bill should be tight...My dollar test seems to just slide on through (not loosely but I can tug it through)
I can't seem to push the door in any farther. I've tried to adjust the door but don't see any other way to do so. Can someone advise me if this is normal "fit" for a Clydesdale, or should I get the factory kit and see if that is better? or do I have a more serious issue going on?
Thanks!
Sure Enjoy The Wood Heat!
Per forum and Internet/videos I picked up new 1/2"gasket cleaned it up and put a small bead of Rutland Cement in.
Paper between door and gasket is tight, but manual and folks here say dollar bill should be tight...My dollar test seems to just slide on through (not loosely but I can tug it through)
I can't seem to push the door in any farther. I've tried to adjust the door but don't see any other way to do so. Can someone advise me if this is normal "fit" for a Clydesdale, or should I get the factory kit and see if that is better? or do I have a more serious issue going on?
Thanks!
Sure Enjoy The Wood Heat!
