combustion motor

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by aaron, Feb 15, 2008.

Thread Status:
Not open for further replies.
  1. aaron

    aaron
    Expand Collapse
    New Member

    Joined:
    Feb 15, 2008
    Messages:
    1
    Likes Received:
    0
    Loc:
    utah
    recently to out combustion motor and took apart put back and apears to be going wrong direction. Which direction is it supose to go. clockwise or other thanks and what would cause difference.
     

    Helpful Sponsor Ads!





  2. jtp10181

    jtp10181
    Expand Collapse
    Minister of Fire

    Joined:
    Feb 26, 2007
    Messages:
    3,729
    Likes Received:
    2
    Loc:
    Madison, WI
    Polarity reversed on the wires going to it could make it go backwards.
     
    Collapse Signature Expand Signature
  3. stoveguy13

    stoveguy13
    Expand Collapse
    Minister of Fire

    Joined:
    Dec 15, 2006
    Messages:
    984
    Likes Received:
    27
    Loc:
    CT
    what kind of stove is it?
     
    Collapse Signature Expand Signature
  4. hearthtools

    hearthtools
    Expand Collapse
    Moderator Emeritus

    Joined:
    Jan 6, 2006
    Messages:
    2,021
    Likes Received:
    30
    Loc:
    Oakhurst, California, USA, Earth
    That would be only on 12 volt
     
    Collapse Signature Expand Signature
  5. stoveguy2esw

    stoveguy2esw
    Expand Collapse
    Minister of Fire

    Joined:
    Nov 14, 2006
    Messages:
    6,163
    Likes Received:
    1,087
    Loc:
    madison hgts. va
    if it was a "c frame" motor the stack could have been put on upside down , this will reverse polarity in an ac motor reversed wires would not , however if a dc motor it will , our poster did dissasemble the motor , depending on how far it was pulled apart it could be a reversed stack
     
    Collapse Signature Expand Signature
  6. hearthtools

    hearthtools
    Expand Collapse
    Moderator Emeritus

    Joined:
    Jan 6, 2006
    Messages:
    2,021
    Likes Received:
    30
    Loc:
    Oakhurst, California, USA, Earth
    Same goes for auger motors
     
    Collapse Signature Expand Signature
  7. stoveguy2esw

    stoveguy2esw
    Expand Collapse
    Minister of Fire

    Joined:
    Nov 14, 2006
    Messages:
    6,163
    Likes Received:
    1,087
    Loc:
    madison hgts. va
    yep , most of them are c frames and can be reversed that way a "shaded pole would not work like that though and i dont know what type is in the unit in question, but im betting thats what happened if he has an ac system
     
    Collapse Signature Expand Signature
  8. hearthtools

    hearthtools
    Expand Collapse
    Moderator Emeritus

    Joined:
    Jan 6, 2006
    Messages:
    2,021
    Likes Received:
    30
    Loc:
    Oakhurst, California, USA, Earth
    Collapse Signature Expand Signature
  9. hearthtools

    hearthtools
    Expand Collapse
    Moderator Emeritus

    Joined:
    Jan 6, 2006
    Messages:
    2,021
    Likes Received:
    30
    Loc:
    Oakhurst, California, USA, Earth
    Collapse Signature Expand Signature
Thread Status:
Not open for further replies.

Share This Page