feed rate stuck in idle after P38 board upgrade

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

Sarhang

New Member
Nov 4, 2012
1
Upgraded a ten year old Harmon P38 with a P38+ circuit board. Now the distribution motor runs full time no matter what feed or temp settings I choose [including OFF], the status light continually blinks 3 times, and the feed motor light stays out, except for brief intervals when the feed motor comes on [about 3 seconds per minute]. The feed rate is just enough to keep the stove running. Any ideas on what may be the problem? Thanks, jmc
 
Status
Not open for further replies.