New control board installed!

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
lessoil

lessoil

Minister of Fire
May 31, 2008
731
Western Maine
Northern Lights out of Farmington came over this week and installed the new board.
Old one had a dead spot on temp control around 72Deg. Also the Off position on the
stove mode/room mode was flakey.
3 yr warranty on electronics is up in October.

Ready to Rock n Roll!!
 
Status
Not open for further replies.

Similar threads

Don Myers
Harman XXV won’t run in Room Temp Mode
Replies
7
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Golfeur
Golfeur
T
Harman P61 burnt circuit board
Replies
8
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
Kazo
K
T
King 5502M Won't Run After Auger Replacement
Replies
2
Views
812
The Pellet Mill - Pellet and Multifuel Stoves
Timelord83
T
K
Lennox Montage 32FS -- Troubleshooting erratic electrical issue
Replies
4
Views
1K
The Pellet Mill - Pellet and Multifuel Stoves
KeepinWarmInTheMidwest
K
A
Pelpro 130-b control board
Replies
2
Views
3K
The Pellet Mill - Pellet and Multifuel Stoves
aklk
A
Top Bottom
Back