I am using an old homemade hydraulic, pto driven splitter. I have the pto attached to an Alice WD-45. I hooked it up today and at low rpm's It started stopping the pto, I could see the pto shaft stop turning where it attaches to the pump. This was when I applied a load by attempting to split the first log. When I moved the splitter ram without a log it did not do this. It was stopping it just for a second or less at a time, very jerky like, intermittent. I shut it down.
I know nothing about hydraulic motors. Where do I need to start? Thanks in advance for any input!
I know nothing about hydraulic motors. Where do I need to start? Thanks in advance for any input!