Q&A Vermont Castings RADIANCE 2240

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
QandA

QandA

New Member
Staff member
Nov 27, 2012
0
Question:

I JUST BOUGHT THIS STOVE CONVERTED TO LP GAS. AFTER HOOK UP THE PILOT WILL NOT CATCH. THE FLAME OF THE PILOT LIGHTS BUT WILL NOT HOLD ITS OWN. CAN YOU GIVE ME A SUGGESTION FOR THIS PROBLEM.



Answer:

Chances are that the "fail-safe" switch on the stove was jarred during transportation or installation. If this happens, the stove will not light until it is reset. Consult your dealer and look into your installation manual for information about resetting the safety switch.
 
Status
Not open for further replies.

Similar threads

B
Replacement pilot assembly for Vermont Castings Radiance 2240 (early 90's?) stove
Replies
2
Views
839
It's a Gas!
Fingerlakes Fireplace
F
I
Replacing the ember bed and manifold on a Vermont Castings Radiance (Sealant required?)
Replies
4
Views
959
It's a Gas!
itech20
I
tbear853
Vermont Castings saved our bacon this week.
Replies
1
Views
375
The Pellet Mill - Pellet and Multifuel Stoves
stoveliker
stoveliker
S
Vermont Casting Radiance RVF33 vent free propane stove
Replies
1
Views
2K
Vermont Castings
Woodsplitter67
Woodsplitter67
R
Vermont Castings RNV40 LP. Pilot goes out when after turning knob to "ON"
Replies
16
Views
4K
It's a Gas!
Canonpdx
C
Top Bottom
Back