Thread Status:

Not open for further replies.

1. augerin New Member

   joined: Oct 5, 2008

   8 posts

   Mi

   ANOTHER REBUILD QUESTION: I REBUILT THIS STOVE ABOUT 10YRS AGO AND AM DOING IT AGAIN. EVERYTHING IS GOING PRETTY GOOD EXCEPT I CAN'T REMEMBER HOW TO CHANGE THE THERMOSTAT CABLE--USING THE ORIGINAL CABLE AS A PULL WIRE---DO YOU PULL FROM THE CONTROL HANDLE DOWN OR FROM THE BOTTOM UP?? DOES IT MATTER? THANKS, TOM

   augerin, Dec 26, 2008

   #1

   Helpful Sponsor Ads!

   ---

   ---
2. DAKSY Super Moderator

   joined: Dec 2, 2008

   4,034 posts

   Averill Park, NY, on Burden Lake II...

   IIRC, the last couple of rebuilds that I did on these ole guys, I hadda make a tool that inserted thru the lower back & pulled the cable down from the top to the opening in the rear...
   Seems like I hadda bend up a clotheshanger to a certain configuration in order to get around inside the air chambers & up to the side where the wire was mounted...
   HTH

   DAKSY, Dec 26, 2008

   #2

Thread Status:

Not open for further replies.

Your name or email address:

Do you already have an account?

Forgot your password?

• No, create an account now.
• Yes, my password is:

Stay logged in