Rod?? you out there?
My neighbor just replace both blower motors and swears it was unpluged while he worked on it. Now when he starts it the blowers both work but the auger is stuck on low. The room blower is stuck on low and the lights on the control board are flashing on and off. Is there a way to reset the board?? Any ideas. I will check and make sure the themostat connections are bridged.
Mark
My neighbor just replace both blower motors and swears it was unpluged while he worked on it. Now when he starts it the blowers both work but the auger is stuck on low. The room blower is stuck on low and the lights on the control board are flashing on and off. Is there a way to reset the board?? Any ideas. I will check and make sure the themostat connections are bridged.
Mark
