Convert Prefab Fireplace
- Views Views: 13,397
- Last updated Last updated:
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
-
Converting a prefab or zero clearance fireplace to produce more heat
You’ll find some other long posts in our Forums about the subject, but here is a summary to make it easier….
Two choices:
1. Most economical – buy a fireplace insert that BOTH fits and is approved for use in pre-fab fireplace – line chimney to the top with new stainless liner and connect to stove.
2. Other: Rip out ENTIRE assembly, firebox and chimney and replace with new metal chimney and stove or built-in high efficiency fireplace
You cannot take just any old stove and place it in front or in and pipe up. It must be an insert approved for such use. This is because of two reasons –
first: the chimney in many prefabs is not tested with anything other than the open fireplace and is not as heavy duty.
second: there is wood in the walls a few inches from your fireplace and a stove in front – and it’s pipe – will not meet the required clearances. Here is another article on the subject with more info:
http://www.hearth.com/econtent/index.php/articles/upgrading_a_pre-fab