our logo
The Chimney Sweep Online Fireplace, Woodstove, Gas Stove and Barbecue Shop

CLEARANCES TO COMBUSTIBLE WALLS

Pacific Energy Neo 1.2 Wood Stove

STOVE DIMENSIONS: 27-1/8" WIDE X 13 1/2" DEEP X 31-3/4" TALL

CONNECTOR PIPE USED: 6" SINGLE-WALL OR DOUBLE-WALL STOVEPIPE


NON-COMBUSTIBLE 1/4" THICK HEARTH (FLOOR PROTECTION) REQUIRED 
MINIMUM HEARTH EXTENSION FROM BACKPLATE OF STOVE: 0"
MINIMUM HEARTH EXTENSION FROM SIDES OF STOVE: 3-1/8"
MINIMUM HEARTH EXTENSION IN FRONT OF STOVE DOOR: 16"
PE Neo 1.2 Clearance Diagram 
    FLAT WALL INSTALLATIONS: 
    CORNER INSTALLATIONS: 
A: STOVE TO BACKWALL:
   SINGLE-WALL STOVEPIPE....... 11"
   DOUBLE-WALL STOVEPIPE........ 9"
   MOBILE HOME.................. 9" 
G: STOVE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE....... 7"
   DOUBLE-WALL STOVEPIPE....... 3"
   MOBILE HOME................. 3" 
B: STOVE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE........ 8"
   DOUBLE-WALL STOVEPIPE........ 7"
   MOBILE HOME.................. 7" 
H: CENTERLINE PIPE TO CORNER WALLS:
   SINGLE-WALL STOVEPIPE...... 18"
   DOUBLE-WALL STOVEPIPE...... 14"
   MOBILE HOME................ 14" 
C: CENTERLINE PIPE TO BACKWALL:
   SINGLE-WALL STOVEPIPE....... 14"
   DOUBLE-WALL STOVEPIPE....... 12"
   MOBILE HOME................. 12" 
I: DIAGONAL FROM CORNER TO FRONT LOP:
   SINGLE-WALL STOVEPIPE....... 53"
   DOUBLE-WALL STOVEPIPE... 47-1/3"
   MOBILE HOME............. 47-1/3" 
D: CENTERLINE PIPE TO SIDEWALL:
   SINGLE-WALL STOVEPIPE... 21-1/2"
   DOUBLE-WALL STOVEPIPE... 20-1/2"
   MOBILE HOME............. 20-1/2" 
J: CORNER TO EDGE OF HEARTH:
   SINGLE-WALL STOVEPIPE... 49-1/3"
   DOUBLE-WALL STOVEPIPE... 45-1/3"
   MOBILE HOME............. 45-1/3" 
E: MINIMUM HEARTH WIDTH.... 33-3/8" 
L: WIDTH OF FRONT EDGE..... 33-3/8" 
F: BACKWALL TO FRONT OF HEARTH:
   SINGLE-WALL STOVEPIPE... 40-1/2"
   DOUBLE-WALL STOVEPIPE... 38-1/2"
   MOBILE HOME............. 38-1/2" 

COMBUSTIBLE ALCOVE DIMENSIONS:  
MINIMUM 41-1/8" Wide X 84" Tall
MAXIMUM 36" Deep


Setting up the Neo 1.2 to burn air from outside the house

OUTSIDE AIR SUPPLIED FROM VENTILATED CRAWLSPACE
Outside Air through Floor Diagram
Locate the 4" round air intake knockout plate at the extreme rear of the underside of the ash box enclosure, just inside the right leg.  Insert a length of 4" rigid or flexible aluminum intake pipe which extends down through a 4-1/8" hole in the floor, terminating below the floor joists and insulation. Caulk around the intake pipe where it penetrates the floor and silicone cement a piece of 1/4" wire rodent mesh to the bottom.
OUTSIDE AIR SUPPLIED THROUGH BACKWALL
Outside Air through Backwall Diagram
 
Locate the 4" round air intake knockout plate at the extreme rear of the underside of the ash box enclosure, just inside the right leg.  Insert a length of 4" rigid or flexible aluminum intake pipe and elbow back through a 4-1/8" hole in the outside wall behind the stove. Attach a standard 4" dryer vent termination on the outside of the wall, removing the flapper plate and substituting a piece of 1/4" rodent mesh silicone-cemented in place.

Install Manual Button
Click to View or Download the installation manual in .pdf format

Click to return to our Pacific Energy Neo 1.2 Wood Stove page. For other options, click a button below.

Wood Stoves Button       Pacific Energy Button       Home Button

The Chimney Sweep, Inc.
913 Harris Avenue
Bellingham, WA 98225-7032
1(888)-354-6722 toll-free in U.S. & Canada
1(360)-676-9080 FAX
http://www.chimneysweeponline.com

To send us E-Mail, Click Standard E-Mail Window or Contact Us Button (our reply form)
Copyright © 1996 - 2019 The Chimney Sweep, Inc.