Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
I light stove manualy with a torch and did not like it had fire behind burn pot any ideas why? im gonna buy a new igniter tommorow and install and clean stove again did not like fire behind burn pot what would cause this ?
BEHIND the burn pot? You mean inside the auger tube a bit? Are there pellets in the hopper?
Is it still on? If so, grab some pellets and throw them in the burn pot til it's about half full. Make sure the stove is set to on. Shut door. They should catch. Enjoy the heat.
If its off, turn it on and to manual ignite, fill the pot halfway with pellets, light the pellets with your torch, leave the door open about an inch for a min, shut door, enjoy heat.
BEHIND the burn pot? You mean inside the auger tube a bit? Are there pellets in the hopper?
Is it still on? If so, grab some pellets and throw them in the burn pot til it's about half full. Make sure the stove is set to on. Shut door. They should catch. Enjoy the heat.
If its off, turn it on and to manual ignite, fill the pot halfway with pellets, light the pellets with your torch, leave the door open about an inch for a min, shut door, enjoy heat.
I saw in your other post you mentioned a feed door. Do you mean the hopper door? If it's not closing properly that MIGHT be your problem getting it to feed and possibly auto ignite. Check the troubleshooting section in your manual.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.