Help with an old fireplace

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

OldStoneHouse

Member
Jan 8, 2010
91
Eastern Ontario
Our house is about 160 years old and we have a fireplace in our front room. About a hundred years ago (my guess) the original fireplace was modified and an insert was installed.

I had one of the local chimney sweeps come out and look at it and he said we were fine to use it occasionally. He pulled it out and told me how to clean out the debris that was behind the insert which I did. The same person checked the chimney from the roof earlier and it had not been used since.

The issue we have is that it doesn't draw very well. I belief that the chimney is clean. I noticed this weekend though that if the cast iron cover is on while a fire is burning, it draws much better. If the cover is off, it is a very poor fire. There is an adjustable grate that I have open as well as a door that says "open when lighting fire." If I close the door then smoke comes back into the room. I can get more pictures of the inside of the insert tonight if that would help.

Thanks for your comments!

Brad
 

Attachments

  • 8.jpg
    8.jpg
    81.5 KB · Views: 170
Looks like the old inserted burner is almost as old as the fireplace. I'm wondering if this possibly was set up for coal burning? Seeing the inside and the grate would be helpful.

To answer your question, this may be a situation where the wood being burned is not fully seasoned. You might try a modest fire with some cut off carpentry scraps. If that burns much better and without the smoking, then the wood supply is suspect.
 
Begreen caught it - that is a coal basket in the fireplace. The flue may not be large enough to handle the greater exhaust volume of a wood fire and coal flues typically did not have the smoke shelf that helps with drafting a wood fire.

Dry wood, cut up into small peices that fit the basket but even so you might not have good results.
 
Hi Brad,
I think begreen may be right in that this style of fireplace is mostly used for burning coal, have one similar in my bedroom.
Usually when burning wood in an open fireplace they use a firebasket similar to this -
valencia-fire-basket-no-back.jpg

Hope this helps.

Billy.
 
Wow... I'm impressed. Have I mentioned recently how amazing hearth.com is?
 
  • Like
Reactions: Billybonfire
I think you need a fireplace grate and your wood is not dry enough.
 
Wow... I'm impressed. Have I mentioned recently how amazing hearth.com is?

I agree with that Joful, a fantastic pool of knowledge, best site in the world for woodburners, and believe me I have looked.
 
Thanks - I'll take some more pictures of the inside tonight. The wood is quite dry, it's been split for two summers - covered as well.
 
Here are the other pictures, they aren't the best but the lighting is difficult at this time of year.
 

Attachments

  • IMG_0114.JPG
    IMG_0114.JPG
    198.1 KB · Views: 123
  • IMG_0115.JPG
    IMG_0115.JPG
    219.8 KB · Views: 128
  • IMG_0117.JPG
    IMG_0117.JPG
    220.4 KB · Views: 121
Status
Not open for further replies.