Table top & saw vise.

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

bogydave

Minister of Fire
Dec 4, 2009
8,426
So Cent ALASKA
Hard to file a chain with out a vise.
Made a saw vise & mounted it to a piece of plywood for a table top just for working on the chains saws.
Now I can clamp it on the little roll around table & keep the roll around table top clean.

Table top:
1 saw tbl top.JPG

Vise: 3 layers of 3/4" plywood, 1/2 all thread, 1/2 NC nut, 1-1/2" square aluminum for the moveable jaw.
/Drilled a 1-1/4" hole in the plywood then cut down to the hole ("off centered" for the stationary jaw) & for chain clearance.
Drilled & tapped the end of the all thread & counter sink screw to hold on the aluminum jaw. Nail for the turning handle.
1Saw vice1.JPG 1Saw vice2.JPG

!saw tbltop & saw1.JPG

Table top & saw in vise:
1Saw on tbl in vice.JPG
 
  • Like
Reactions: ScotO
Don't think I've ever used a vise when sharpening. Throw the saw on the tailgate and hold the bar with one hand and file with the other.
 
I never did either. But after reading some of the guys post who mentioned clamping the bar in a vise for sharpening, I tried it.
Pretty easy & faster with a vise. Live & learn ;)

Now I have a portable one in the shop, which is where I do most of the sharpening.
May make one for the ATV rack, speeds up the sharpening & I think I do a better job filing with it held in place securely . :)
 
Don't think I've ever used a vise when sharpening. Throw the saw on the tailgate and hold the bar with one hand and file with the other.

In the field, I do the same. At home, when I'm sharpening several chains, I prefer the vise. More accurate, less mess.
 
Worked pretty nice.
Allot quicker & easier to sharpen a chain.
Down side so far, I have filings going into the the threads of the all thread & nut
& need to round (or 45°) the outboard corner of the vise, knuckles hit the corners of the vise filing the small saw.

DSCF0461.JPG DSCF0463.JPG DSCF0460.JPG
 
  • Like
Reactions: ScotO
I have a 6" vise bolted to an oak 2"x10" about 2' long with a double layer of ice/water shield tacked to the bottom to keep it from sliding around. Great for sharpening on the tailgate of the job truck and fixing other stuff on site.
 
  • Like
Reactions: ScotO
I have a 6" vise bolted to an oak 2"x10" about 2' long with a double layer of ice/water shield tacked to the bottom to keep it from sliding around. Great for sharpening on the tailgate of the job truck and fixing other stuff on site.

A real good idea.
Sure helps to have that extra hand when out in the field.

Do you use anything on the jaws to protect the bar? That's why I thought of wood & aluminum.
I guess the bar gets thrown away when worn out . Nothing for the vise to damage .
 
Very cool Dave ! I clamp mine into the batch vise with the power head on so I can lock the chain and take my time it works great !

Pete
 
Status
Not open for further replies.