First 1 Ton Cleaning - XXV

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
Regular Maintenance - 2 Week Run

I usually clean out the fire box every weekend. But this time I let it go two weeks maybe
three or about 14 bags. Note: I have not been in the igniter area for about a month.
xxv.before.1.jpg xxv.before.2.jpg

Here is what the burn pot looked like after a few days with no attention.
xxv.pot.before.jpg

I used the 17" pry bar to remove the bulk followed by the small flat screwdriver
to clean carbon from the auger, auger tube and flat area around the tube. Since
I was going for a deep clean I finished off the burn pot with Scotch Brite.
xxv.pot.after.jpg

I keep a 90 deg pick handy for the air holes but they were fine.
xxv.burn.pot.holes.jpg

On to the igniter area. I tapped on the top of the burn pot to knock loose ash off the igniter.
Then went under for the clean up. I used a small hose connected to the vacuum to get way
down in there.
xxv.under.pot.before.jpg xxv.under.pot.after.jpg

Below shows the fire box clean. Flame guide wire brushed and the heat exchanger
cleaned with the 2" paint brush. Followed up on the exchanger with the Scotch Brite.
xxx.after.box.jpg xxv.after.box.2.jpg

Well, that about wraps it up. I was really curious to see what the inside of
the stove and venting would look like after 1 ton. Not to bad IMO. I think the XXV
is doing well.

I would have liked to get more pictures of "doing things" like a "how to" but I was a bit
short on time and taking pictures of all this really slows down the progress.
I will flesh things out next round when I do..."A Ton of Cleaning". :)


xxv.done.jpg
 
Thanks. How long does it take your P61 to fill the ash pan? Choice of pellet? I have gone 2 weeks without basic cleaning aside from scraping the pot a few times a week. I want to say the ash pan is 1/3 - 1/2 full at that point. The ash pan is much bigger on the P61 if I recall.

Book states with a good quality pellet, empty ash pan after every ton burned.
We are going about 4-5 weeks. Burning MWP. Locally made and delivered. About $220/ton as I remember.
 
Mr.Spock- Bravo! and a big thank you for this informative post!! I have only torn down my XXV once and the details you provided in this thread will surely help me on my next cleaning. The pictures were extremely helpful.
 
Dang! Very thorough cleaning! Much better than what I do. :(
Thanks. The positive feeback appreciated. geez...I thought everybody cleaned there stove like this! Well most everybody...a hear lot on this site clean, clean, clean. Didn't want to post a half a$$ job ;)
 
Thanks. The positive feeback appreciated. geez...I thought everybody cleaned there stove like this! Well most everybody...a hear lot on this site clean, clean, clean. Didn't want to post a half a$$ job ;)
Well you certainly did a great job! How much you charge? ;)
 
  • Like
Reactions: Mr. Spock
Mr.Spock- Bravo! and a big thank you for this informative post!! I have only torn down my XXV once and the details you provided in this thread will surely help me on my next cleaning. The pictures were extremely helpful.
Your welcome! Next time you clean, post your insides! I for one would like to see what others find when they clean.
 
  • Like
Reactions: rwreuter
I just bought a XXV myself and have been just surface cleaning. I was wondering when I needed to do a thorough cleaning.....now I know......1 ton and I will rip into her. I certainly was hoping to just do a thorough cleaning once a season.
 
Congrats on your purchase! The XXV is on its second full season and no complaints. She has been a fine stove. I am over a ton since the last teardown/ cleaning so I want to get on it soon. I did a quick inspection of the venting and things look ok so I am not to uncomfortable. Burning Okies this year and they are a much cleaner pellet then the Geneva I burned last season.
 
Last edited:
Just got my newborn(porcelain)XXV a little over a week ago, sure puts out some great heat quick when you need it!
These stoves are great as they are made to be easy to work on and clean , I'm liking mine more every day.

Thank you for the informative thread w/the great pics!
 
Just got my newborn(porcelain)XXV a little over a week ago, sure puts out some great heat quick when you need it!
These stoves are great as they are made to be easy to work on and clean , I'm liking mine more every day.

Thank you for the informative thread w/the great pics!
Your welcome. Would like to do a cleaning video...will see if time is on my side.
 
  • Like
Reactions: rwreuter
Love your post. Great pics! I do what I thought was a fairly decent cleaning every two weeks. I scrape burn pot, clean fines box, brush out combustin flu to the ESP probe, scrape exchanger and brush out all interior surfaces and vacuum out igniter chamber. I have a very short 3" vent to the outside, no vertical run at all, terminating only 18" or 2 ft from the house with a 45* down elbow and critter grate. Also have the Harman wall thimble for the OAK combo vent. I will clean out that last 3 ft from the ESP to the vent termination point in the spring.
 
Status
Not open for further replies.