For whatever reason I don’t know I am going to do the slots for my Grandma baffle. A 3 x 3 slot in each corner is easy to define but if it is 2 x 3 slot I need to know the orientation. Should it be 3 left to right or 2 left to right? After a test period I will report back after it is slotted with the results.
Slot For My Grandma Baffle
- Thread starter Frankdozer
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Great picture but it does not explain the dimensions of the slot in relation to the baffle.
Yes, 2 inches in from from front edge, 3 inches across. Post #92 in the Baffle Thread gives notch dimensions.
www.hearth.com
This doesn't change the square inch smoke space by much, unless the baffle is already short and not reaching the lower top plate. The smoke space, or square inch area the exhaust flows through is the most important.
Simple Baffle Solution for your old FISHER ! More Heat Less Smoke under $25
well lets see, last year I decided to try to load n/s a tight rack . Well I'll NEVER do that again:eek: . We got HOT like 900 + stove top temp . I figure if this old Fisher was gonna warp it would have done it then . ALSO the baffle is floating in place (not welded wall to wall) so how? .( this...
www.hearth.com
This doesn't change the square inch smoke space by much, unless the baffle is already short and not reaching the lower top plate. The smoke space, or square inch area the exhaust flows through is the most important.
Similar threads
