Installing new chimney and stove pipe to wonderluxe stove.

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.

ScottChristian

New Member
Aug 30, 2022
2
Kentucky
Wanting to replace
Old 12.5 in galvanized chimney outer pipe that held the 8 inch single wall,
To a 6 inch ss chimney,. Then into a double wall black stove pipe.
Then to a T section(dvl-t) that connects to stove vent.
Haven't torn into anything yet. But wondering what a huge hole there must be at the roof. Hope it's not much more than 13". But it may be.
Will the flashing that comes with dt620 kit cover such a large hole?
What is best way to make this large hole a tighter fit to a 6dt-60sscf pipe as well as the roof flashing that comes in the kit.....
+- a 15" hole to the duravent 8" diameter
 
Check with Duravent support. I think the flashing is about 20" wide and 27"? long. If that won't work it may be better to get the parts individually. Duravent makes a large base flashing if needed.
+- a 15" hole to the duravent 8" diameter
Is this for a different chimney?
 
Check with Duravent support. I think the flashing is about 20" wide and 27"? long. If that won't work it may be better to get the parts individually. Duravent makes a large base flashing if needed.

Is this for a different chimney?
I'm ripping out old chimney that had the single wall running up through it. The ceiling box is awful looking at the least 16618941284168369897107944181594.jpg