CAB50 Help!

Hope i didnt screw up...

My HVAC buddy told me that my search for a digital thermostat is a simple one.

So i went and got a simple Honeywell T2 non-programmable thermostat and hooked up the R to the red wire and the W to the white...and it called for heat, the pellets dropped, the fire raged,...but the fan to blow the heat wouldnt come on! Now, it is important to note that i tested the unit with the old t-stat before the change, and it worked fine.

So i switched back to the old t-stat again, and now it just runs the exhaust fan...no pellets drop, nb flame, no nadda.

HELP!

It seems I got it working...

I took out the auger and cleaned out the chute, then reset the snap discs, and low and behold, it started up like an old car...hesitate, but eventually got running.

My convection fan is whining a little, but I think it is still under warranty.

The stove kicks on a LOT though, if the temp goes down 1 degree, then it kicks on. I remember reading about how some go down 3-4 degrees, THEN calls for heat. Wonder if I can change that rate on my new thermostat.

magomeara said:

Could you please tell me how to reset the snap discs? I've seen this mentioned but can't find directions.

Thanks!

Click to expand...

Hi there

Im pretty certain that there is a button in the middle of them, and they make a “snap” sound when depressed.