There was a blinking light that I did not recognize. Someone in Youtube suggested to just clean the ESV probe, but now I still have that blinking light and a new more serious problem, the igniter does not want to heat up anymore. Any suggestions?
Harman P68 igniter issues
- Thread starter jordan69s
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
mtnbiker727
Feeling the Heat
bogieb
Minister of Fire
Northwoodneil
Feeling the Heat
A 4 blink would for sure. That code means it's not reading the room temp probe so it goes into shut down mode but I believe the igniter would work when the stove is set on stove temp mode.
bogieb
Minister of Fire
Yes, both of them would. #3 requires a "reset" (unplug stove for a couple of minutes then plug back in). #4 "should" correct itself when the issue is taken care of, but I would do a reset anyway once you have cleaned the ESP and made sure all its connections are correct and tight..
Similar threads
