Hello everybody!
I’ve noticed that Heatilator CAB50 is pretty constantly feeding pellets during a burn cycle.
It kicks on, does a feed, ignites, sometimes waits a minute before feeding more (didnt use to do that i think), then more….and more….a few seconds and…more….little more…and goes on that way.
I dont see an excessive amount of ash that would lead me to believe its going thru more pellets, but i dont recall it being as consistent feeding.
Whatcha think? Thermocouple maybe? Board issue?
TIA
I’ve noticed that Heatilator CAB50 is pretty constantly feeding pellets during a burn cycle.
It kicks on, does a feed, ignites, sometimes waits a minute before feeding more (didnt use to do that i think), then more….and more….a few seconds and…more….little more…and goes on that way.
I dont see an excessive amount of ash that would lead me to believe its going thru more pellets, but i dont recall it being as consistent feeding.
Whatcha think? Thermocouple maybe? Board issue?
TIA
