Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Recently picked up a new, never used 385xp. Ran about two tanks of fuel through it. Ran like a champ. Brought it inside to blow it off with some air. Fresh fuel mix, I have spark. Now she won't start. I checked the obvious, what's next?
Seems very wet. That's just from pulling the cord. Any previous time starting, push in decompression button, pull out choke, pull cord,would generally kick, push in choke, pull again, then it would fire.
Try first 2 pulls with no choke, before pulling choke out. or try half choke. full choke is to much for my saws unless they are completely cold. on warm starts, no choke at all.
Well, monkeyed around abit with it today. Tried no choke with decomp in. Just about fired up right away. A few more pulls, nothing. Pulled decomp out, fired right up.
Bad decomp? Very strange, just afraid to rip the cord out, done that, what a groan to get back together.
I had the decomp stick on my husky a few times. I think mostly cause I failed to use it on a regular basis. gave it a couple good push/pulls and a shot of carb cleaner. now that the saw is broken in havent had a problem with it. It would sound like it would almost run with the decomp in, giving a half fire half pfft sound. now that you have heard that sound, you'll recognize that issue again right away!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.