I have a pelpro 130 probably 10 years old. its ran fine except a igniter a few years ago. anyhow, this years it ran fine went started and after about a month to 6 weeks of running the control KNOW and blinking light started acting up. sometimes it would blink has if starting up,and never start, or just stay in the slow blink mode has if you had the stove off no matter where the knob was positioned. sometimes after unplugging the sdtove and plugging back in or spinning the knob back and forth youd get lucky and it would come on. but that was short lived as the light just never came on again. well after researching and YOUTUBE miles pellet stoves told me he had never replaced a control knob board and it was likely the main board. so new main board same problem, then I decide it got to be that control knob board and I get a new one. fixed
YAY! that was about 6 weeks ago and now Iam in the same boat. I decided I would try another main board. well I just put it in and same deal no light.
where can you get a circuit board checked out, Im tired of just throwing money at it.
T I A
YAY! that was about 6 weeks ago and now Iam in the same boat. I decided I would try another main board. well I just put it in and same deal no light.where can you get a circuit board checked out, Im tired of just throwing money at it.
T I A
