My Mendota FV44i has not been used in the last two seasons. Today I replaced batteries in remote and receiver. Then I went through the process to synchronize remote and receiver, and got all the correct beeps according to the instructions. In manual mode, with the pilot switch and receiver switch set to "on", the burners fire up. But when the system is set for remote use, with pilot switch "off" and receiver switch set to "remote", the burners will not go on when I press the remote's on/off button. When I press the on/off button on the remote, the remote goes into its "on" mode, and I hear a beep and click from the fireplace, but I get no flame. Would welcome thoughts on what's wrong and how to fix.
Remote synchronized with receiver but fire won't light
- Thread starter Lars Hanson
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
