New Progress Report, the good, the bad, and the ugly

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.
New report. Have had the stove up to 590. It was throwing nice even heat, but I burned it down in about 4 hours from a pretty full load. Not the most efficient burn ever as far as heat in the house I am sure. It was 15 last night, and the stove had trouble bringing the temp up in the house. It seemed to be able to hold it, but I really had to crank on it to bring the temp up. Once up, it kept the house warm, woke up to a nice bed of coals, and a 68 degree house. I do not think it has quite the brute force the fisher had, but overall am very happy. It is difficult to keep the stove around 600 for a long period of time. 500 is easy

I did finally get a nice hot cat burn. I just needed to wait a bit longer to shut it down. I had been shutting down quickly, but once I waited for 10-15 minutes, the stove did just fine. Kept it over 400 for a loooonnngg time. The top was over 500 for around 2.5 hours. I also think I was letting too much air in. I felt I needed to have a little flame in the box. Apparently I don't. I have never shut it all the way off, but basically there is a point where the metal touches in the butterfly. I leave it about there...I can turn it down another 1/4 in or so if I wanted. I did find I could end the secondaries if I needed to doing this, if I bumped the draft open slightly, they did not relight right away.
 
Status
Not open for further replies.