Rika integra insert error ER2

https://www.hearth.com/talk/posts/565816/

read through the whole thread and they reference er2 as the High Limit Switch error code. That was 2 years ago so who knows. Couldn't find anything online, hope that gets you in the right direction...or you could pm one of those guys in the thread since it seems like there a few with the same stove. Hope you get it going.

Er2 is failure for high limit which is the switch on the right front bottom above the convection blower ... Make sure the leads are connected

Not sure. Call rika peehaps

Nice stove.........
may depend on software # but here is what i have
depends on it the stove is flashing or remains on.
flashing auger off system good...
remains stove shuts down.
i assume stays o9n because stove off.
er2 overheating. i would reset it and see if works
er0 low exhaust gas temp , missing pellets fire out
er1unacceptable config of auger parameters
er3air flow, door gasket, burnpot dirty, intake exhaust etc
er4air flow too low increase fan rpm

if reset doest work try high limit switch........
good luck

high limit is auto reset. the switch is NC (normally closed) any chance that a wire came undone? here is where its located. You can troubleshoot the switch by connecting the two wires together that go to the switch

She2dancer said:

thank you all for that info! We cooled the stove down, cleaned out the heat exchanger panels and baffles, restarted and it started back up no problems! phew! Thankful you folks are here to help!

Click to expand...

She2dancer,
What did you do with your Quadrafire? If you still have it I would be interested in buying some parts from you. Thanks