Harman P38+ Board
- Thread starter gfreek
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
hwdemers
Member
i will be watching this thread to see answers, i too would like to send out a few boards to be refurbished
Bioburner
Moderator
Might be cheaper to buy the pots on Ebay and have a local cell phone and computer repair do the easy job
Whoever does it needs to have good soldering skills.
Replacing the pots should ideally be done by a skilled electronics repair person, or someone familiar with intricate board soldering.
A solder sucker is needed to remove the solder to get at the bent over tabs . The soldered joints run through both sides of the board and can be difficult to remove.
The board itself is fragile and easily ruined if this procedure is not done carefully.
Found two places so far.....http://pelletblowers.com/bbandp/product_info.php/cPath/23/products_id/52
Sells potentiometers and does replacements for a fee..
http://www.ebay.com/itm/Harman-Pell...430?pt=LH_DefaultDomain_0&hash=item2c63f3b2ce
Sells potentiometers and does replacements for a fee..
http://www.ebay.com/itm/Harman-Pell...430?pt=LH_DefaultDomain_0&hash=item2c63f3b2ce
- Status
Similar threads
