I am replacing my damaged analog control board. I just received from Breckwell their c-e-950 upgrade kit. The kit contains the ce-301 board and a new complete wiring harness. Hookup was a breeze, however.....always one of these right? Auger starts feeding immediately. I called breckwell, they couldnt find the schematics that matched the ones sent to me in the kit. Anyway, i unplug the pof disk, auger still runs. Disconnect the connector from the panel and checked for shorts, which there were none. I did notice that the on/off led flashes. They are sending me a new board and I am wondering 3 things.
Has anyone had a problem like this with a bad new board?
Im assuming the jumpers are for btu settings. The p24i is 50,000 btu and it seems like this is set for 60,000. Cant find jumper settings anywhere and pin1 has been removed.
I like my analog control, it was set it and forget it.....for years! Anyone have one for sale or know who repairs them?
Thank ya'all in advance for any help!
Has anyone had a problem like this with a bad new board?
Im assuming the jumpers are for btu settings. The p24i is 50,000 btu and it seems like this is set for 60,000. Cant find jumper settings anywhere and pin1 has been removed.
I like my analog control, it was set it and forget it.....for years! Anyone have one for sale or know who repairs them?
Thank ya'all in advance for any help!
