I have cleaned every inch of this stove...eye, stove pipe, etc. Problem is it won't shut off and has to be unplugged from the wall...any suggestions? Main board?
Thank you
Thank you
Whitfield Profile 20 pellet stove Won't shut off!!!
- Thread starter hoydett
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
- Status
Lake Girl
Moderator
Welcome to the forum. Have you tried troubleshooting the limit switches? Unplug stove first then temporary bypass the switch. Locations found on wiring schematic on page 32
http://www.woodpelletheat.com/ProfileStoveManual.pdf
Keep us posted...
http://www.woodpelletheat.com/ProfileStoveManual.pdf
Keep us posted...
MountainSean
Credo Quia Absurdum
The Profile 20 uses a photo eye, to test to see if that is the problem, just unplug the yellow wires going into the top of the circuit board on the back. Once you do that plug the stove in and start it up. It should only run for a little over 14 minutes and then shut down like no fire is burning. If the stove does shut down after the 14 minute period then you probably have a bad photo eye. If the stove still will not shut down with the photo eye unplugged then you probably have a bad board.
- Status
Similar threads
