This is the information from the manual. If the opening out the pf100 is only 14x18, how can you get the min on the large motor?
Velocity 500fpm 700fpm 900fpm
1000 cfm. 270 in² 210 in² 160 in²
1450 cfm 360 in² 290 in² 220 in²
1638 cfm 470 in² 360 in² 290 in²
Am I missing something here? I know the unit I will be pickign up is the larger one and I can always set it on the lower setting. I am trying to find ducting that I can match the 14x18 into my main trunk of the existing forced hot air. Then from there, it will go through the existing duct.
Thoughts, ideas?
Thanks,
Don
Velocity 500fpm 700fpm 900fpm
1000 cfm. 270 in² 210 in² 160 in²
1450 cfm 360 in² 290 in² 220 in²
1638 cfm 470 in² 360 in² 290 in²
Am I missing something here? I know the unit I will be pickign up is the larger one and I can always set it on the lower setting. I am trying to find ducting that I can match the 14x18 into my main trunk of the existing forced hot air. Then from there, it will go through the existing duct.
Thoughts, ideas?
Thanks,
Don