Hello,
I have a Heat & Glow FB Grand Lp Fireplace Insert that is about two years old and has performed well until this morning when my wife noticed the pilot light wasn't lit and tried unsuccessfully to re-light it with no success.
I gave it a try and the pilot light would light up with one or two clicks of the Pezzio Ingniter but after holding the button in for a minute or sometimes much longer,(according to the owners manual), when I released the button the pilot would go out.
I have a high wind cap installed on the termination end and have never had this problem before. I believe the unit has the SITTS Gas Valve.
Could this possibly be the signs of a bad Thermal Coupler or Thermal Pile,( I still get the two confused), that is shutting the gas valve down and not allowing gas to keep the pilot lit?
Thanks
LB
I have a Heat & Glow FB Grand Lp Fireplace Insert that is about two years old and has performed well until this morning when my wife noticed the pilot light wasn't lit and tried unsuccessfully to re-light it with no success.
I gave it a try and the pilot light would light up with one or two clicks of the Pezzio Ingniter but after holding the button in for a minute or sometimes much longer,(according to the owners manual), when I released the button the pilot would go out.
I have a high wind cap installed on the termination end and have never had this problem before. I believe the unit has the SITTS Gas Valve.
Could this possibly be the signs of a bad Thermal Coupler or Thermal Pile,( I still get the two confused), that is shutting the gas valve down and not allowing gas to keep the pilot lit?
Thanks
LB