I need assistance. I keep getting the E-2 code followed by the E-1 code. This occurs with in 20 seconds of starting the unit. So far this is what I checked.
Ran the diagnostic and the exhaust blower does come on.
I cleaned out the entire unit.
I confirmed all augers are working.
I trimmed off the end of the Vacuum hose that was worn and made sure no other cracks.
Not sure what else to try so I am open to suggestions. I would think that if it was a bad blower it would not engage during the diagnostic.
I tried to call into Englander but I never get off work in time.
Ran the diagnostic and the exhaust blower does come on.
I cleaned out the entire unit.
I confirmed all augers are working.
I trimmed off the end of the Vacuum hose that was worn and made sure no other cracks.
Not sure what else to try so I am open to suggestions. I would think that if it was a bad blower it would not engage during the diagnostic.
I tried to call into Englander but I never get off work in time.