converting insert for shop

Post in 'The Hearth Room - Wood Stoves and Fireplaces' started by JDD48, Jan 1, 2009.

Thread Status:
Not open for further replies.
  1. JDD48

    JDD48
    Expand Collapse
    New Member

    Joined:
    Jan 1, 2009
    Messages:
    1
    Likes Received:
    0
    Loc:
    WV
    New here, lots of good info found so far.
    I have a plate steel insert that was never used and taken out of my inlaws house. Would like to set this up in my shop, don't have to worry about combustibles or fumes, cinderblock building, stove has a 3 and 1/2 inch X 14 inch rectangular opening for smoke on top. Is there an adapter for going from this to 6 or 8 inch pipe? Thanks, Jim.

    edit: Found another thread on this, stove in that one is a silent flame, mine looks identical. found a stack for it at hearthstove.net. Welcome other suggestions/sources though.
     

    Helpful Sponsor Ads!





Thread Status:
Not open for further replies.

Share This Page

Entire Site copyright © 1995-2016 - email to webinfo@hearth.com
Hearth.com and HearthNet are property and trademarks of Hearth.com LLC Advertising Information