Finally getting around to posting some pictures.
Going through the bulkhead, which is located in my Garage. From there, it had to travel about 40' to the opposite side of the house. Easily done with a couple 3' pipes.
While in place, and panels off, I decided to clean the unit. Quite a bit of Creosote.
Turbs were caked and impossible to pull by hand.
My migshift turb puller. I carefully pulled about 1" at a time and made sure they were pulled straight.
All cleaned up.
Tubes thoroughly cleaned.
All cleaned up. New gasket & high-temp silicone for access panels.
Current status. Panels & doors on. All wire up. Supply, Return, & Bypass plumbed. Smoke hood & stove pipe installed.
Going through the bulkhead, which is located in my Garage. From there, it had to travel about 40' to the opposite side of the house. Easily done with a couple 3' pipes.
While in place, and panels off, I decided to clean the unit. Quite a bit of Creosote.
Turbs were caked and impossible to pull by hand.
My migshift turb puller. I carefully pulled about 1" at a time and made sure they were pulled straight.
All cleaned up.
Tubes thoroughly cleaned.
All cleaned up. New gasket & high-temp silicone for access panels.
Current status. Panels & doors on. All wire up. Supply, Return, & Bypass plumbed. Smoke hood & stove pipe installed.