1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Hearthstone Soapstone and Cast-Iron stoves( Wood, Gas or Pellet Stoves and Inserts)

feed rate stuck in idle after P38 board upgrade

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by Sarhang, Nov 4, 2012.

  1. Sarhang

    Sarhang New Member

    Joined:
    Nov 4, 2012
    Messages:
    1
    Upgraded a ten year old Harmon P38 with a P38+ circuit board. Now the distribution motor runs full time no matter what feed or temp settings I choose [including OFF], the status light continually blinks 3 times, and the feed motor light stays out, except for brief intervals when the feed motor comes on [about 3 seconds per minute]. The feed rate is just enough to keep the stove running. Any ideas on what may be the problem? Thanks, jmc

    Helpful Sponsor Ads!





Share This Page