Help with using Biobricks

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

rphurley

Feeling the Heat
Hearth Supporter
Nov 5, 2008
435
Central/Eastern CT
Hi everyone, thanks in advance for the abundance of advice that will be sent my way. This is my first year burning a Regency insert and I am very pleased with it as my oil use has been minimal. I bought a ton of Biobricks to supplement my wood supply because I wasn't sure if I'd have enough wood to get through the season and I havn't been able to figure out the optimal way to stack them so they don't burn to quickly. I don't use them often because I have enough wood to get me through, but I was wondering if I could have some suggestions to get the most of the Biobricks that I bought. Even when I stack them tight and damp down the intake I find the mound burns for a good 1-2 hours and then just glows as a massive pile of embers. Is this the best I can do?
Thanks for your suggestions,
Rich
 
I am about to finish my 3rd ton of BioBricks (all this year) so I am far from expert. But I have had pretty favorable experience with them. If you go to their website they recommend a close stack, the purpose of which is to extend the burn. When I tried this I was able to get longer burns but I did not get a satisfying amount of heat. So I went to a loose fill with plenty of air gaps and have found that works well. I now always use somewhere between 6 and 8 bricks -- fewer doesn't give adequate heat and the one time I went to 10 on a hot bed of coals I got pretty close to an overfire.

For the first fire each morning I go with the 6 or 8 bricks, a piece of a Super Cedar and a small amount of kindling. For refills I just toss them on the coals, let them catch (3 or 4 minutes) and then damper all the way down. I usually have to refill every 3 or 4 hours although there is still some decent heat after burning down overnight for 7 or 8 hours.

I'm guessing that you are not using enough of the bricks, therefore the short burns. Remember they are only 2 pounds each so you can't expect too much out of just using a few. During the real cold weather I have been using at least 2 packages (40 bricks or 80 pounds) every day. I think that is pretty consistent with what the pellet burners use (and there is no reason it should be much different).
 
Great advice guys, I was hoping to get better burn times from them so I will try the really tight stack, but with about 10 bricks or so. Sometimes if you wait too long, you have a pile of embers with no structure and when you put real wood on them they just evaporate away and you can't get ignition of the wood that you just applied.
 
I bought 1/2 ton to supplement my wood supply. What I like to do - i load the back of the stove as much as I can. In the front of the stove (nearest to glass) - I stack 6 bio bricks across the front (1 row of 3 stacked 2 high). What this does for me - creates lots of heat...,keeps the glass clean, gets the wood in the back of the stove burning so well i can shut the stove down and get a good 8 hours of heat. This works will for me - all about trial and error.
 
Status
Not open for further replies.