When doing a deep cleaning on my Francesca, I have the two port covers on either side which are about 2 x 3 with spring bolt retainers. Below each of these covers are smaller plates, about 1 x 2, which are bolted on and seem to be sealed with red silicone. These two smaller covers do not show up on my schematic. Do they need to be removed for complete cleaning? They seem like they will need to be prayed off then resealed. Thanks for any help.
Ravelli internal cleaning question
- Thread starter Manly
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
I don't remove the lower ones just the uppers, but since I have started to use the LBT I found that does a good job and no longer need to pull anything apart.
Similar threads
