Thermostat Question

  • Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.

    We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.

    We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Status
Not open for further replies.

magellan900

Member
Hearth Supporter
Nov 21, 2008
10
Upstate NY
I'm looking for a thermostat for my Santa Fe that allows me to set a temperature cycle range. I want to be able to tell the stove to heat up the room to say 65 degrees, but not come on again until the temperature drops to say 60. Is this something that's available?

Thanks. Great site.

Duane

Quad Santa Fe burning 50% corn
 
Not to be a pain, but....why?

Why would you want to let the temperature fluctuate over such a large range?
 
sure is , lux makes one $30.oo at lowes
i have one one on my castile works perfect
and it will do what you mentioned above
 
I just installed a Lux TX9000TS touch screen programmable on my Quadra-Fire Castile. It has an adjustable swing of up to 2.25 degrees. The t-stat will call for heat at 2.25 degrees below the set value and shut down 2.25 degrees above. Set it to 63 with a 2.25 swing and it's pretty much what you're looking for. Purchased on eBay for around $50.
 
Almost every thermostat can do that. It's called something along the lines of a differential. You set the stat for 60* program the differential for 5* and presto.
 
Corie said:
Not to be a pain, but....why?

Why would you want to let the temperature fluctuate over such a large range?

Maybe less ignition cycles? I keep mine on a 4 degree swing for that reason.
 
Correct. Mainly for when I'm not home. I work weekends(12hrs each day)and rather than setting it at 60 and have it ignite all day keeping it there, I'd rather have less ignition cycles. My current t-stat has no such cycle settings. Thanks for the replies.

Duane
 
so I take it that it kicks back on without going into any kind of shut down or start up mode
 
Yes, and it does so without any issues. I have a leaky house at the moment and don't need it maintained so accurately when I'm not home.

Duane
 
donkarlos said:
so I take it that it kicks back on without going into any kind of shut down or start up mode

The Quadra-Fire stoves will shut down when the t-stat stops calling for heat. The unit will stop feeding pellets and the blowers will run for about 20min at which point the stove shuts off completely. When the t-stat calls for heat again, after the room temp drops back by the swing value, the unit will drop pellets, turn on the blower fan, and heat the igniter. Once the pellets catch and the unit runs up to a certain temp the convection blower starts and it pumps out heat running the t-stat back to the cut-off. Mine shut down about 7pm and with the 4 degree swing around the set value of 70 it stayed off for about 2.5 hours and It's is 25 degrees outside my drafty old house. The shutdown gave me some time to clean the burn-pot.
 
Status
Not open for further replies.