1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Jotul Cast Iron Stoves
    Woodstock Soapstone Stoves
    Hearth and Home (QuadraFire and Harman Stoves)

Whitfield Advantage II Lights Flashing --No blowers speeds

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by 69800, Apr 8, 2008.

Thread Status:
Not open for further replies.

  1. 69800 Member

    joined: Oct 29, 2007
    45 posts
    Troy Idaho
    Rod?? you out there?

    My neighbor just replace both blower motors and swears it was unpluged while he worked on it. Now when he starts it the blowers both work but the auger is stuck on low. The room blower is stuck on low and the lights on the control board are flashing on and off. Is there a way to reset the board?? Any ideas. I will check and make sure the themostat connections are bridged.

    Mark
    69800, Apr 8, 2008
    #1

    Helpful Sponsor Ads!

Thread Status:
Not open for further replies.

Share This Page