1. Welcome Hearth.com Guests and Visitors - Please enjoy our forums!
    Hearth.com GOLD Sponsors who help bring the site content to you:
    Hearthstone Soapstone and Cast-Iron stoves( Wood, Gas or Pellet Stoves and Inserts)
    Caluwe - Passion for Fire and Water ( Pellet and Wood Hydronic and Space Heating)

xxv up and running now!

Post in 'The Pellet Mill - Pellet and Multifuel Stoves' started by Jim H., Sep 15, 2008.

Thread Status:
Not open for further replies.
  1. Jim H.

    Jim H. Feeling the Heat

    Joined:
    Jul 16, 2008
    Messages:
    348
    Loc:
    N.E. Pa. (Northampton County)
    had it in place and the owner came over this morning and we did a dry run. put the 6" pipe from the top
    of the stove to a elbow then right into the fireplace. didn't even seal it yet. noticed a very very small amount
    of smoke only at startup at the top of the stove only where the 6" pipe is only laying on top! will still probably seal it i think. i noticed it is very very quiet even on the highest fan
    setting. did someone mention a switch for a higher fan? will take pics next time it is running...still a little warm
    in pa right now.

    jim

    Helpful Sponsor Ads!





  2. swalz

    swalz Feeling the Heat

    Joined:
    Jan 2, 2008
    Messages:
    271
    Loc:
    Newark, DE
    There is a high/low switch on the side of the stove, when you open the control panel look inside you will see it.
Thread Status:
Not open for further replies.

Share This Page