Bought a house with a Ashley 5660 US stove. Owner said is was recently broken. He ordered a controller board and it did not fix the issue. With the old board in there is no power/lights/ any signs of life except for the constant alarm from the speaker on the board. Attach new board and the fan and runs as well as the auger however no lights on the control board but it also constantly alarms. Tested fuses on power board and jumpered the over temp sensor. Ideas? Thanks
5660E bay front pellet stove no power
- Thread starter Dan in FT Lupton
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
tlc1976
Minister of Fire
Which temp sensor did you jumper?
I wonder if the overheat switch tripped. On my stove it is a manual reset switch with a pushbutton. More than likely it’s a thermodisc on the back of the heat exchanger near the room blower.
I wonder if the overheat switch tripped. On my stove it is a manual reset switch with a pushbutton. More than likely it’s a thermodisc on the back of the heat exchanger near the room blower.
Last edited:
Similar threads
