The control board went out in my castille and I replaced it. The old board light would flash four times when first plugged in. The instructions for the new board said to set it on six. My flame is anywhere from 8 to 10 inches high while runnimg, instruction say 6 inches. My pellet feed gate is slid close as far as it will go. Can I just set the new board on 5 and then adjust the gate to regulated the flame height?
Castille control box setting.
- Thread starter unioncreek
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
Similar threads
