I bought a used Cemi Concept II insert last year. We just had our fireplace and chimney cleaned and inspected. I installed the insert this evening. However the “faceplate” or surround is just a bit too small for my fireplace. Does anyone know how or where I can find something a bit larger to try and keep all of my heated air from escaping up the chimney?
Cemi Concept II
- Thread starter SouthernINBrnr
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil.
Put a block-off plate in the damper area to seal off the chimney.
www.hearth.com
Why damper seal is needed, block off plate install
Should fireplace inserts and hearth stoves have a metal sealing plate installed at the damper area? Here is the simple answer. It is almost impossible to correctly seal most insert panels to the fireplace front. A lot of air can get through them - this works both ways.....hurts the draft when...
www.hearth.com
For some reason it won’t allow me access to the reference article. The insert I have does not vent directly to the chimney. Rather it vents into the fireplace. So I don’t believe I can seal off the damper area.Put a block-off plate in the damper area to seal off the chimney.
Why damper seal is needed, block off plate install
Should fireplace inserts and hearth stoves have a metal sealing plate installed at the damper area? Here is the simple answer. It is almost impossible to correctly seal most insert panels to the fireplace front. A lot of air can get through them - this works both ways.....hurts the draft when...
Similar threads
