Hi folks. Well, I changed the combustion motor (bearing were going), changed vaccum switch which was shot (feed motor wasnt feeding at all) changed ESP, and changed distro motor (just plain old). Pellets still feed slow and the flame remains around 4 -5 inches high on room or stove temp. Put feed and temp dials all the way up and nothing changes...any insights or ideas would be much appreciated..thanks all
changed everything, but pellets arent feeding fast enough....
- Thread starter bacitup88
- Start date
-
Active since 1995, Hearth.com is THE place on the internet for free information and advice about wood stoves, pellet stoves and other energy saving equipment.
We strive to provide opinions, articles, discussions and history related to Hearth Products and in a more general sense, energy issues.
We promote the EFFICIENT, RESPONSIBLE, CLEAN and SAFE use of all fuels, whether renewable or fossil. -
Super Cedar firestarters 30% discount Use code Hearth2024 Click here
- Status
Hmmm...I guess if you've verified that you have 120VAC at the receptacle, the only thing left to replace is the control board...
ugh...I was hoping that wasnt the case. Seems to feed, just not long enough each cycle to increase warmth
it seems like the feed motor cycles long enough (up to 60 seconds at a time) but enough of the pellets just arent making it into the burn pot
- Status
Similar threads
